Threaded Stainless Steel Y Strainer

Threaded Stainless Steel Y Strainer

Threaded stainless steel y strainer is an indispensable filtration device for pipeline system of transporting medium, Y-type filter is usually installed at the inlet end of pressure reducing valve, pressure relief valve, water level valve or other equipment to remove impurities in the medium to protect the normal use of valves and equipment. Y-type filter can be used for water, oil and gas. Generally, the water mesh is 18~30 mesh, the gas mesh is 10~100 mesh, and the oil mesh is 100~480 mesh. The basket filter is mainly composed of receiver, main tube, filter blue, flange, flange cover and fasteners. When the liquid enters the filter blue through the main tube, the solid impurity particles are blocked in the filter blue, while the clean fluid is discharged through the filter blue and from the filter outlet.

Product Categories

1.Air filter To clean the polluted air to the state needed for production and life, that is, to make the air reach a certain degree of cleanliness.

2. Liquid filter To clean the contaminated liquid to the state required for production and life, that is, to make the liquid reach a certain degree of cleanliness.

3. Network filter By setting up to block spam, the information appearing on the computer screen will meet the requirements as much as possible. The same principle of absorption will be different colors of light separation

4. Light filter, absorbing some unwanted light. The above should be a mesh filter, in fact, there are many kinds of filters, such as stacked filters, sand filters, carbon filters and so on, the main principle is to use the pore size of the filter media to retain smaller than the media pore size of the material, of course, some filter media also have a special effect such as adsorption. Most filters are not that troublesome to backwash, as long as the media in the reverse backwash filter is introduced from one end of the filtered water to achieve a good backwashing effect. This type of valve should generally be installed horizontally in the pipeline.